URGENT! Problem accessing the Switch(SW1) in free-lab Lab#3

[ccna_y001]

Hi,

I had a lab session this afternoon. Everything went fine until I had to configure the SW1(switch in Lab#3). When I entered the option-6 I saw the below display...I couldn't enter the switch console to do the configs. Can anybody help on this please?

Thanks

1) R1
2) R2
3) R3
4) R4
5) R5
6) SW1
7) Reset Power to All Devices
Cool Email Configurations

Selection [1-8]: 6
6 was selected, corresponding to device labcon SW1


+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Free-Labs.com | Expert-Labs.com
Terminal (lab3/SW1)
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|CTRL-B send Break, CTRL-C to Quit|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

Please use only 'cisco' for passwords

(press any key to continue)








Diagnostic Console - Generic I/O


-----------------Settings------------------

[A] Autoincrement address Yes
[F] From address location 0000H (0)
[L] Length in 16-bit words 0001H (1)
[T] Toggle byte/word display Word
[V] Value for output 0000H (0)

-----------------Actions-------------------

[I] Input
[O] Output

[X] Exit to Previous Menu

Enter Selection: X






Diagnostic Console - System debug interface


[G] Generic I/O
[M] Memory (CPU) I/O
[F] Return system to factory defaults
[R] Reset main console RS232 interface to 9600,8,1,N
[V] View management console password

[X] Exit to Previous Menu

Enter Selection: